Digital Step Temperature Control Relay DTA-96

Temperature controller (two-channel thermostat) with timer and heating profile - automatically adjusting PID controller, for panel or device installation. Step temperature controller. Dimensions 96x96x90 mm.

Unlike cheap analogs, the TENSE thermostat allows setting temperature limits and the time in which the temperature should reach the set values. This significantly simplifies the programming process. The PID mode further enables maintaining the system temperature as close as possible to the set values.

Another important difference compared to competitors is the simultaneous display of current temperature, set temperature, control step, and time. The presence of control buttons START/STOP/PAUSE/SET on the front panel is very convenient – it allows quick and efficient management of your technological processes.

Main features:

• You can select one of the operating modes: P, PI, PD, PID or simply ON-OFF

• Two relay control outputs OUT and ALARM, optionally you can set the OUT output to a semiconductor relay

• Adjustment up to 20 temperature levels / heating stages

• Each stage is programmable up to 18 hours of operation

• Option for automatic selection of PID control parameters

• Wide selection of temperature sensors for connection to the thermostat — T/C (J, K, T, S, R) or Pt100

• Automatic reduction of "overshoot" in PID mode

• Built-in Anti-windup function — compensation for integrator saturation effect

• Option to select absolute, relative, or range values for the ALARM contact

• Possibility to set upper and lower levels for SET and ALARM

• The controller display shows two temperature values — 4 digits of 7-segment display for the set temperature value and 4 digits of 7-segment display for the current measured temperature by the controller, as well as time interval values and step count

• Built-in compensation of the cold junction temperature effect for T/C type sensors (cold junction compensation) 0...50°C

• Linear compensation for Pt100 type temperature sensors connected to the thermostat up to 10 Ohms

• Possibility to set the temperature measurement offset value for the thermostat –100...+100°C

• Password protection for temperature controller parameters

• The temperature controller has very high accuracy of adjustment and time intervals

• Energy-independent memory (EEPROM) for storing settings

• Easy connection to the controlled device — all connections are made using quick-clamp terminals

• Optionally available power supply 24 V DC or AC

• Installation height — up to 2000 m above sea level

• Temperature sensor is not included in the delivery

• Please do not forget to order a fuse for protecting the power circuits and control/signal contact.

Measurement scales (ranges):

Sensor tip — range:

• –100 .. 600 °C, tip J T/C, (InPt = J)

• –100 .. 1300 °C, tip K T/C, (InPt = k)

• –100 .. 400 °C, tip T T/C, (InPt = t)

• 0 .. 1750 °C, tip S T/C, (InPt = S)

• 0 .. 1750 °C, tip R T/C, (InPt = r)

• –100 .. 600 °C, Pt100 (InPt = Pt)

• –99.9 .. 600.0 °C, Pt100 (InPt = Pt.0)